2025 Realistic Verified FCP_FWF_AD-7.4 exam dumps Q&As - FCP_FWF_AD-7.4 Free Update
Use Real FCP_FWF_AD-7.4 Dumps - 100% Free FCP_FWF_AD-7.4 Exam Dumps
NEW QUESTION # 40
When using FortiPresence as a captive portal, which two types of public authentication services can be used to access guest Wi-Fi?
(Choose two.)
Response:
- A. Short message service authentication
- B. Social networks authentication
- C. Hardware security token authentication
- D. Software security token authentication
Answer: A,B
NEW QUESTION # 41
How can you find upstream and downstream link rates of a wireless client using FortiGate?
Response:
- A. On the FortiAP CLI, using the cw_diag ksta command
- B. On the FortiGate CLI, using the diag wireless-controller wlac -d Sta command
- C. On the FortiAP CLI, using the cw_diag -d sta command
- D. On the FortiGate GUI, using the WiFi Client monitor
Answer: D
NEW QUESTION # 42
Which tools can assist in troubleshooting wireless network issues on FortiGate?
(Select all that apply)
Response:
- A. Encryption key generator
- B. RF spectrum analyzer
- C. Packet capture analyzer
- D. DHCP lease tracker
Answer: B,C
NEW QUESTION # 43
Which action would be most appropriate when a rogue AP is detected?
Response:
- A. Increase the number of active APs in the area.
- B. Assign a new SSID to the rogue AP.
- C. Update the firmware of the rogue AP.
- D. Suppress or quarantine the rogue AP.
Answer: D
NEW QUESTION # 44
Refer to the exhibits.
FortiGate is pushing the POST parameters shown in the exhibit to the external captive portal server The wireless client redirection fails because certificate validation occurred while loading the web page The wireless client browser uses the FortiGate self-signed certificate to access secured web pages The SSID on FortiGate has the captive portal setting What could cause the certification validation error on the wireless client?
- A. The used credential is not embedded in the captive portal parameters
- B. The external server address is not the FQDN address
- C. The FortiGate IP address in the POST parameters is using a numerical IP address
- D. The captive portal setting in the authentication setting is set to use FQDN as the captive portal type
Answer: C
NEW QUESTION # 45
Which of the following is a requirement to generate analytic reports using on-site FortiPresence deployment?
Response:
- A. SQL services must be running
- B. Wireless network security must be set to open
- C. DTLS encryption on wireless traffic must be turned off
- D. Two wireless APs must be sending data
Answer: A
NEW QUESTION # 46
Using the FortiGate guest management feature, what can be provisioned for wireless networks?
Response:
- A. FortiAP profiles
- B. Guest accounts
- C. VLAN configurations
- D. Advanced bridge mode options
Answer: B
NEW QUESTION # 47
What is the main advantage of deploying FortiAP devices using FortiAP Cloud?
Response:
- A. Enhanced threat analytics and monitoring
- B. Simplified deployment and centralized management
- C. Direct access to FortiGate configurations
- D. Predictive modeling capabilities for network expansion
Answer: B
NEW QUESTION # 48
A tunnel mode wireless network is configured on a FortiGate wireless controller. Which task must be completed before the wireless network can be used?
Response:
- A. The new network must be manually assigned to a FortiAP profile.
- B. The wireless network to Internet firewall policy must be configured
- C. Security Fabric and HTTPS must be enabled on the wireless network interface
- D. The wireless network interface must be assigned a Layer 3 address
Answer: B
NEW QUESTION # 49
The purpose of FortiAP and client load balancing is to:
Response:
- A. Provide guest access to the network.
- B. Minimize the cost of FortiAP deployment.
- C. Optimize wireless client distribution across multiple access points.
- D. Encrypt traffic between FortiAP and FortiGate.
Answer: C
NEW QUESTION # 50
What is the first step in troubleshooting client connection issues on a wireless network managed by FortiGate?
Response:
- A. Verify VLAN configurations
- B. Review the client's signal strength
- C. Check the SSID broadcast settings
- D. Analyze packet captures
Answer: B
NEW QUESTION # 51
Which factor is the best indicator of wireless client connection quality?
Response:
- A. Downstream link rate, the connection rate for the AP to the client
- B. The channel utilization of the channel the client is using
- C. Upstream link rate, the connection rate for the client to the AP
- D. The receive signal strength (RSS) of the client at the AP
Answer: C
NEW QUESTION # 52
Which two statements are true about AP profiles?
(Choose two.)
Response:
- A. An AP must be authorized before having a profile applied.
- B. AP profiles are model specific.
- C. A FortiAP profile must be applied to a FortiAP group.
- D. A profile must be applied manually to an AP before it can be managed by FortiGate.
Answer: A,B
NEW QUESTION # 53
What is the purpose of configuring WPA3 encryption on a wireless network?
Response:
- A. To improve wireless signal strength
- B. To enable load balancing for wireless clients
- C. To provide strong security for wireless communications
- D. To manage guest accounts on the network
Answer: C
NEW QUESTION # 54
Which configurations are required when deploying FortiAP devices using FortiAP Cloud?
(Select all that apply)
Response:
- A. Set up FortiPresence analytics for monitoring
- B. Apply predictive modeling using FortiPlanner
- C. Configure FortiAP profiles in FortiAP Cloud
- D. Manage AP settings centrally through the cloud platform
Answer: C,D
NEW QUESTION # 55
For protecting against wireless network intrusions, you would configure:
Response:
- A. Wi-Fi signal boosters.
- B. WIDS profiles.
- C. Bandwidth management profiles.
- D. DHCP options.
Answer: B
NEW QUESTION # 56
......
Fortinet FCP_FWF_AD-7.4 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
Pass FCP_FWF_AD-7.4 exam Updated 169 Questions: https://passleader.dumpexams.com/FCP_FWF_AD-7.4-vce-torrent.html